23 February 2012

Let there be light 2

Following on from previous blog entry, we moved on to instal light fitting to the corridor.

from the day of photoshoot

The corridor has a finished ceiling of 3.4m, it is 1.7m wide and 11.5m long... something one would not expect in an ordinary house (but then again, who said Seatondale is an ordinary house?).

opening up the package to understand the wiring requirement

cutting the cable housing which was too long..it came with 2.5m and we only need 1m 
threading through the base plate

fixing the base plate

the assistant has to hold the light fitting while the electrician does the wiring

 assistant: "quick...I can't hold this anymore....!!"

the assistant also needs to stablise the electrician on the high ladder

 finally the first fitting is up, then we need to ensure the fitting is levelled on all sides

"...a bit lower there..." 



starting up the second fitting installation.. first measure the centre of the fitting

inside the ceiling there is no adequate structure to hold up the fitting, so we need to add an extra support (timber piece) to make sure the fitting is not only supported on the plasterboard (the plasterboard is not strong enough to hold the weight of the fitting)

making sure the timber is at the right place

this time the assistant knows to place the fitting on his head rather than holding with his hands..this way it is easier

this one was relatively fast in installation

 two down, one more to go

cutting the ceiling

careful.. careful....

 

checking if all corners are the same distance from the ceiling (the red thing on the light fitting is the level)

 

...and if all corners are the same distance from the floor (with construction, especially old houses like Seatondale, it is very likely that walls are not straight ceilings are not levelled, to name a few)

lets tuck this wire in..

after almost 4 hours the 3 light fitting are finally installed!

No comments:

Post a Comment